Follow Me On The Web!

The Internet Defense League

23 December, 2012 Posted by Christopher Jenner Posted in General Processing Principles
1 comment

Flocculation Basics in Processing

flocculation processing

Following or during coagulation another process known as flocculation occurs. In flocculation the primary means of attraction is by weak van der Wall’s forces. These forces are encouraged through increased retention time and decreased mixing energy. The process yields particles that are visible to the naked eye, unlike coagulation which yields microscopic microflock’s.

In flocculation rapid mixing is not promoted, instead high retention time and low energy agitation is desirable. The low energy agitation promotes greater microfloc/particle contact and in turn allows the formation of larger suspended particles known as pinfloc’s. These pinfloc’s continue to grow as retention time increases. The resulting macrofloc’s are visible to the naked eye, and can be removed from the medium by mechanical or gravitational means. Flocculant reagents can be added to increase strength, weight and decrease settling time. They can be anionic, cationic or non-ionic. Care should be taken when using a coagulant of the opposite charge. This will avoid the reagents neutralising charges and becoming ineffective.

The effectiveness of flocculation is greatly dependant on the mixing energy and velocity of the medium. The weak inter-molecular van de Waal’s forces holding the flocs together can be sheered or broken easily when subjected to a high energy environment. In general the greater the velocity and higher the mixing energy, the smaller the floc’s.

The flocculation process is also affected by pH, salts, alkalinity, turbidity, temperature and degree of mixing.

Retention time for flocculation varies greatly but typically is longer than 15 minutes. Through extensive jar testing an optimal time can be found.

To find the theoretical retention time, use the equation for retention time (also known as detention time)

Retention time = basin volume / volume per minute flow

Obtain the rise rate from,

Rise rate = volume per minute flow / net up-flow area of basin

Green, Don, and Robert Perry. Perry’s Chemical Engineers’ Handbook. McGraw-Hill Companies, 2007.
G.L.Hayett. “Engineering Handbook: Technical Information.” New York: Industrial Press Inc., 2004.
The following two tabs change content below. is my personal blog that allows me to share some of the knowledge I have gained on the road to becoming a chemical engineer. My goal is to create a site that supports the exchange of information through tutorials, presentations, articles and blog entries. Feel free to contact me with suggestions or feedback.

Latest posts by Christopher Jenner (see all)

1 comment

  1. My brother was recently admitted to the hospital for a cut he got on his leg. I remember the doctor saying something about flocculation, but I had no idea what that was. I didn’t know that it was a process during or after coagulation that provides particles that are visible to the naked eye to help provide blockage after a laceration. That seems like a very important process, especially for my brother right now.

Leave a Reply on Tomas Killington

Leave a Reply to Tomas Killington Cancel reply

Your email address will not be published. Required fields are marked *